Error 7BAT_OVP1VanMoof S3 / X3

VanMoof Error 7 on your S3 or X3: battery voltage too high

Error 7 is listed in the error code list as BAT_OVP1: Over Voltage Protection 1. The battery management system measures a higher voltage than permitted and steps in. That can be caused by the charger, by a cell going out of balance or by the BMS measuring incorrectly. Which of the three it is can only be established with measuring equipment.

Try this yourself first

  1. Are you using a charger other than the original VanMoof one? Then try the original: an adapter that supplies too high a voltage is the most common cause.
  2. Let the bike run a full charge cycle with that charger and see whether the code comes back.

Didn't work, or does the message come back? Then we'll take a look.

Symptoms

  • The display shows Error 7
  • The fault appears during or just after charging
  • The bike switches off on the charger
  • The charge percentage jumps back and forth illogically

Possible causes

  • A non-original or faulty charger supplying too high a voltage
  • Cells that have gone out of balance
  • A BMS that reads the voltage incorrectly

How VanFoom fixes Error 7

  1. 1Checking and measuring the charger, as the first suspect
  2. 2Voltage measurement per cell to rule out imbalance
  3. 3Balancing, BMS repair or battery replacement with certified parts
  4. 4A full charge cycle as a test before handover

Bring your charger when you come in: that way we can rule it out straight away. Usually ready within 7 working days.

Error 7? We'll fix it.

Book your repair online or give us a call. From S2 to S6, every error code, every part, with genuine VanMoof parts and a warranty.