Error 4BAT_UVP2VanMoof S3 / X3

VanMoof Error 4 on your S3 or X3: battery deeply discharged

Error 4 is listed in the VanMoof error code list as BAT_UVP2: Under Voltage Protection 2. The battery voltage has dropped below the safe lower limit and the battery management system has switched the battery off. The manufacturer explicitly notes that a longer charging session can clear the fault. If the code is still there afterwards, there's more going on and a battery diagnosis is needed.

Try this yourself first

  1. Connect the original charger and leave the bike on charge for at least 12 hours without interruption, even if nothing seems to happen. The manufacturer explicitly names this as a possible fix.
  2. Do this indoors, at room temperature: a cold battery charges barely or not at all.
  3. Then check whether the code has gone and whether the battery charges again.

Didn't work, or does the message come back? Then we'll take a look.

Symptoms

  • The display shows Error 4
  • The bike won't turn on or switches off straight away
  • The battery doesn't seem to charge, or barely
  • The bike has been left unused for a long time

Possible causes

  • The battery has run down too far from standing still for a long time
  • Cells that no longer hold their charge
  • A BMS that won't release the battery again after deep discharge

How VanFoom fixes Error 4

  1. 1Full battery diagnosis with measuring equipment if a longer charge didn't help
  2. 2Measuring the voltage per cell to see whether the pack can still be saved
  3. 3Repairing the BMS module or cells, or fitting a certified battery
  4. 4Charge test over several cycles before handover

If a long charging session doesn't help, we're usually done within 7 working days.

Error 4? We'll fix it.

Book your repair online or give us a call. From S2 to S6, every error code, every part, with genuine VanMoof parts and a warranty.