Error 46MOTOR_MOTOR_OVER_CURRENTVanMoof S3 / X3

Error 46 on your VanMoof S3 or X3: motor control overheated

Error 46 is called MOTOR_MOTOR_OVER_CURRENT: the power stage of the motor control reports overheating. The electronics that supply the motor with power went over their temperature limit. That can be caused by heavy load, but also by the motor drawing more current than it should. A measurement under load tells the two apart.

Try this yourself first

  1. Stop and let the bike cool down for fifteen minutes to half an hour, preferably in the shade.
  2. Then ride in a lower assistance level, especially on a long climb or in warm weather.
  3. If assistance works normally again after cooling down, the bike was protecting itself. If it comes back on ordinary rides, have it checked.

Didn't work, or does the message come back? Then we'll take a look.

Symptoms

  • The display shows Error 46
  • Assistance cuts out after climbing or accelerating hard
  • After cooling down, the bike works again
  • The motor or the front wheel feels warm

Possible causes

  • Prolonged heavy load: normal, protective behaviour
  • A motor drawing more current because of internal wear
  • A fault in the power electronics of the motor control

How VanFoom fixes Error 46

  1. 1Reading out the error history to assess the pattern
  2. 2Current and temperature measurement on the motor under load
  3. 3Repair or replacement of the motor or its control with genuine VanMoof parts
  4. 4Test ride with a load test before handover

Only after a long climb? Often normal. On ordinary rides, we'll measure it through: usually ready within 7 working days.

Error 46? We'll fix it.

Book your repair online or give us a call. From S2 to S6, every error code, every part, with genuine VanMoof parts and a warranty.